Mazda 6 Service Manual: General information
Mazda 6 Service Manual / General information
- How to use this manual
- Units
- Fundamental procedures
- Protection of vehicle
- Preparation of tools and measuring equipment
- Special service tools
- Oil leakage inspection
- Disconnection of the negative battery cable
- Removal of parts
- Disassembly
- Inspection during removal, disassembly
- Arrangement of parts
- Cleaning of parts
- Reassembly
- Adjustment
- Rubber parts and tubing
- Hose clamps
- Torque formulas
- Vise
- Dynamometer
- Sst
- Installation of radio system
- Electrical system
- Jacking positions ,vehicle lift (2 supports),safety stands (rigid rack) positions
- Towing
- Identification number locations
- New standards
- Abbreviations
- Pre-delivery inspection
- Scheduled maintenance
Mazda 6 Service Manual
...
Other materials:
Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over.
2. Disengage clips A using a fastener remover.
3. Pull the A-pillar trim, then disengage clip B (1).
4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar
trim (2).
5. Pull clip B out, then rotate 45°.
6. Remove clip B from the grommet b ...
Mazda 6 Service Manual: Dtc clearing procedure
1. Start the on-board diagnostic test mode.
2. First press the POWER button, then simultaneously press AUDIO CONT button
for 2 seconds or more.
Caution
Before clearing the DTCs, be sure to enter all of them displayed
in the on-board diagnostic test mode in the Audio Repair Order Form. ...
© 2016-2026 Copyright www.mazda6info.net