Mazda 6 Service Manual: Range of topics
- This manual contains procedures for performing all required service operations. The procedures are divided into the following five basic operations:
Removal/Installation Disassembly/Assembly
Replacement
Inspection
Adjustment
- Simple operations which can be performed easily just by looking at the vehicle (i.e., removal/installation of parts, jacking, vehicle lifting, cleaning of parts and visual inspection) have been omitted.
Service procedure
Inspection, adjustment
Inspection and adjustment procedures are divided into steps. Important
points regarding the location and contents of the procedures are explained
in detail and shown i ...
Other materials:
Mazda 6 Service Manual: Rear wiper arm and blade removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE
ADJUSTMENT)
Rear Wiper Arm Installation Note
Clean the rear wiper arm connector shaft using a wire brush before installing
the ...
Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle recognition.)
3. Select Module programming.
4. Select Programmable module installation.
5. Select PCM and perform procedures according to directions on the WDS
screen.
Note
If PCM CONFIGURATION is successful, the PCM ...