Mazda 6 manuals

Mazda 6 Service Manual: Electrical system

Installation of radio system
If a radio system is installed improperly or if a high-powered type is used, the CIS and other systems may be affected. When the vehicle is to be equipped with a radio, observe the following preca ...

Electrical parts
Battery cable Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable. Wiring Harness To remove the wiring harness from the clip in the en ...

Other materials:

Mazda 6 Service Manual: Drive shaft removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...

Mazda 6 Service Manual: Oil pressure switch removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait untill they are cool before replacing ATF. 1. Disconnect the negative battery cable. 2. Remove the under cover. 3. Disconnect the cord assembly connector. 4. Remove the oil pressure switch. ...

© 2016-2025 Copyright www.mazda6info.net