or equivalent combination, the written torque must be recalculated due to the extra length that the SST
or equivalent adds to the torque wrench.
Recalculate the torque using the following formulas. Choose the formula that applies to you.

A : The length of the SST
past the torque wrench drive
L : The length of the torque wrench

Hose clamps
ViseMazda 6 Service Manual: Pcm removal/installation
Note
For replace the PCM, Setup the WDS and perform the PCM
configuration. (See PCM CONFIGURATION.)
1. Disconnect the negative battery cable.
2. For R.H.D, perform the following procedures.
(1) Remove the front side trim (left-side).
(2) Partially peel back the flower covering.
3 ...
Mazda 6 Service Manual: Joint shaft removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor and fix it to an appropriate place wh ...