Mazda 6 Service Manual: New standards
- Following is a comparison of the previous standard and the new standard.
#1 : Diagnostic trouble codes depend on the diagnostic test mode
#2 : Controlled by the PCM
#3 : In some models, there is a fuel pump relay that controls pump speed. That relay is now called the fuel pump relay (speed).
#4 : Device that controls engine and powertrain
#5 : Directly connected to exhaust manifold
#6 : Part name of diesel engine
Identification number locations
VEHICLE IDENTIFICATION NUMBER(VIN)
ENGINE IDENTIFICATION NUMBER
...
Abbreviations
...
Other materials:
Mazda 6 Service Manual: Pcm inspection
Note
PIDs for the following parts are not available on this model. Go
to the appropriate part inspection page.
- CMP sensor (See CAMSHAFT POSITION (CMP) SENSOR INSPECTION.)
- Main relay (See RELAY INSPECTION.)
1. Connect the SST (WDS or equivalent) to the DLC-2.
2. Turn the igni ...
Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there is a
problem, check to make sure conne ...