Mazda 6 Service Manual: Inspection during removal, disassembly

Mazda 6 Service Manual / General information / Fundamental procedures / Inspection during removal, disassembly

When removed, each part should be carefully inspected for malfunction, deformation, damage, and other problems.

Disassembly

If the disassembly procedure is complex, requiring many parts to be disassembled, all parts should be marked in a place that will not affect their performance or external appearance and ident ...

Arrangement of parts

All disassembled parts should be carefully arranged for reassembly. Be sure to separate or otherwise identify the parts to be replaced from those that will be reused. ...

Other materials:

Mazda 6 Service Manual: A-pillar trim removal
1. Turn the seaming welt over. 2. Disengage clips A using a fastener remover. 3. Pull the A-pillar trim, then disengage clip B (1). 4. Pull the A-pillar trim upward, then disengage clip B from the A-pillar trim (2). 5. Pull clip B out, then rotate 45°. 6. Remove clip B from the grommet b ...

Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket. 2. Disconnect the DSC HU/CM connector. 3. Connect the SST (49 G066 004) to the DSC HU/CM connector and harness side connector. 4. Inspect voltage referring the table below. Terminal Voltage Table (reference value) (Ignition switch is at ON, and conne ...