Mazda 6 Service Manual: Disconnection of the negative battery cable
- Before beginning any work, turn the ignition switch to LOCK position,
then disconnect the negative battery cable and wait for more than 1 minute
to allow the backup power supply of the SAS unit to deplete its stored
power. Disconnecting the battery cable will delete the memories of the
clock, audio, and DTCs, etc. Therefore, it is necessary to verify those
memories before disconnecting the cable.
- If the battery had been disconnected during vehicle maintenance or for
other reasons, the window will not fully close automatically.Carry out the
power window main switch initial setting. (See INITIAL SETTING.)
Use either of the following procedures to identify the type of oil that
is leaking:
Using UV Light (Black Light)
1. Remove on the engine or transaxle.
Note
Referring to the fluorescent ...
While correcting a problem, also try to determine its cause. Begin work
only after first learning which parts and subassemblies must be removed and
disassembled for replacement or repair. Aft ...
Other materials:
Mazda 6 Service Manual: Rear brake (disc) removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, depress the pedal several times, rotate the wheel by
hand, and verify that the brake does not drag.
Disc Pad Installation Note
1. Turn the manual adjustment gear counterclockwi ...
Mazda 6 Service Manual: Cup Holder
WARNING
Never use a cup holder to hold hot liquids while the vehicle is moving:
Using a cup holder to hold hot liquids while the vehicle is moving is dangerous.
If the contents spill, you could be scalded.
Do not put anything other than cups or drink cans in cup holders:
Putting objects othe ...