Mazda 6 Service Manual: Warning and indicator system
- Instrument cluster removal/installation
- Instrument cluster configuration
- Instrument cluster disassembly/assembly
- Instrument cluster inspection
- Instrument cluster repair
- Instrument cluster input/output check mode
- Pid/data monitor and record procedure
- Fuel gauge sender unit inspection
- Oil pressure switch inspection
- Horn removal/installation
- Information display removal/installation
Headlight cleaner switch inspection
1. Disconnect the negative battery cable.
2. Remove the headlight cleaner switch. (See HEADLIGHT CLEANER SWITCH
REMOVAL/INSTALLATION)
3. Inspect for continuity between the headlight cleaner switch ...
Instrument cluster removal/installation
Caution
When replacing the instrument cluster, the configuration procedure must be
performed before removing the instrument cluster. If the configuration procedure
is not performed before remo ...
Other materials:
Mazda 6 Service Manual: Cooling (With air conditioner)
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the cold position.
3. Set the fan control dial to the desired speed.
4. Turn on the air conditioner by pressing the A/C switch.
5. After cooling begins, adjust the fan control dial and temperature control
d ...
Mazda 6 Service Manual: No.3 passenger-side air bag cut-off indicator light does not illuminate
Diagnostic Procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure connec ...