Mazda 6 manuals

Mazda 6 Service Manual: Instrument cluster disassembly/assembly

Mazda 6 Service Manual / Body electrical system / Warning and indicator system / Instrument cluster disassembly/assembly

Caution

1. Disassemble in the order indicated in the table.



2. Assemble in the reverse order of disassembly.

Instrument cluster configuration
1. Connect the SST (WDS or equivalent) to the DLC-2. 2. Input vehicle information following the directions on the screen. 3. Select Module programming. 4. Select Programmable module installation. ...

Instrument cluster inspection
Speedometer Using the input/output check mode Inspect the speedometer by setting it in the input/output check mode DTC 12. Using a speedometer tester 1. Adjust the tire air pressure to the specifi ...

Other materials:

Mazda 6 Service Manual: Oil cooler flushing
Note The contaminated cooler line (oil pipes and hoses) and auxiliary cooler must be flushed completely when ATX is overhauled or replaced. 1. Remove the two oil cooler line hoses and apply air pressure of 196 kPa {2.0 kgf/cm2, 28 psi} from the return hose (pipe) side. Caution Power ...

Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2. 2. Set up the WDS (including the vehicle recognition.) 3. Select Module programming. 4. Select Programmable module installation. 5. Select PCM and perform procedures according to directions on the WDS screen. Note If PCM CONFIGURATION is successful, the PCM ...

© 2016-2026 Copyright www.mazda6info.net