Mazda 6 manuals

Mazda 6 Service Manual: On-board diagnostic

Barometric pressure (baro) sensor inspection
Note Perform the following inspection only when directed. The following vacuum values are indicated by relative pressure from the barometric pressure sensor. 1. Connect the SSTs (WDS or eq ...

Foreword
When the customer reports a vehicle malfunction, check the malfunction indicator lamp (MIL) indication and diagnostic trouble code (DTC), then diagnose the malfunction according to following ...

Other materials:

Mazda 6 Service Manual: Actuator cable installation
1. Slide the lock lever in the direction shown by the arrow to unlock the adjuster. 2. Turn the ratchet ring to release lock in the direction shown by the arrow. 3. Install the actuator cable to the cruise actuator. Caution Due to the possibility of actuator cable damage, make sure th ...

Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and ...

© 2016-2026 Copyright www.mazda6info.net