Mazda 6 manuals

Mazda 6 Service Manual: Dtc confirmation procedure


Diagnostic monitoring test results
The purpose of this test mode is to confirm the result of OBD monitor diagnostic test results. The result values stored when particular monitor is completed are displayed. If the monitor is not ...

Koeo/koer self-test
1. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 2. Perform KOEO/KOER self-test. ...

Other materials:

Mazda 6 Service Manual: Refrigerant pressure switch removal/installation
1. Remove the battery. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Loosen the refrigerant pressure switch using two spanners. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. Refrigerant Pressure Switch Installat ...

Mazda 6 Service Manual: Expansion valve removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) Caution If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug open fitt ...

© 2016-2026 Copyright www.mazda6info.net