
Diagnostic procedure



Dtc p0118
Dtc p0122Mazda 6 Service Manual: Filament repair
1. Use isopropyl alcohol to clean around the damaged section of the filament.
2. Attach tape above and below the damaged section of the filament.
3. Using a small brush or marking pen, repair the filament with silver paint
or equivalent.
4. After 2-3 minutes, carefully remove the tape without ...
Mazda 6 Service Manual: Seat warmer switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the brake boots panel. (See CONSOLE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Seat Warmer Switch Removal Note
Squeeze the tabs of seat warmer switch and pull it forwar ...