Mazda 6 Service Manual: Air bag system
- Service warnings
- Driver-side air bag module removal/installation
- Passenger-side air bag module removal/installation
- Side air bag module removal/installation
- Curtain air bag module removal/installation
- Crash zone sensor removal/installation
- Side air bag sensor removal/installation
- Sas unit removal/installation
- Sas unit configuration
- Clock spring removal/installation
- Clock spring adjustment
- Clock spring inspection
- Passenger-side air bag cut-off indicator light removal/installation
- Air bag module and pre-tensioner seat belt deployment procedures
- Air bag module and pre-tensioner seat belt disposal procedures
- Inspection of sst (deployment tool)
Cruise control switch inspection
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
3. Disconnect the cruise control switch connector.
4. In ...
Service warnings
Component Disassembly
Disassembling and reassembling the components of the air bag system
can render the system inoperative, which may result in serious injury or
death in the event of an ac ...
Other materials:
Mazda 6 Service Manual: Displayable Range on the Screen
The images on the screen may be different from the actual conditions.
NOTE
The displayable range varies depending on the vehicle and road conditions.
The displayable range is limited. Objects under the bumper or around
the bumper ends cannot be displayed.
The distance appearing in the ...
Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while
doing the inspection to discover whether poor contact points are the cause
of any intermittent malfunction. If
there is a problem, check to make sure connectors, terminals and ...