Warning
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove the headliner.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds
and then goes off.


Connector Removal Note
1. Using a flathead screwdriver, pry out the connector's stopper plate.

2. Disconnect the connector.
Curtain Air Bag Module Installation Note (4SD Right Side)
Pass the curtain air bag module harness through the hole in the body.

Side air bag module removal/installation
Crash zone sensor removal/installationMazda 6 Service Manual: Keys
WARNING
Do not leave the key in your vehicle with children and keep them in a place
where your children will not find or play with them: Leaving children in a
vehicle with the key is dangerous. This could result in someone being badly injured
or even killed. Children may find these keys to be ...
Mazda 6 Service Manual: Shift-Lock System
The shift-lock system prevents shifting out of P unless the brake pedal is depressed.
To shift from P:
1. Depress and hold the brake pedal.
2. Start the engine.
3. Press and hold the lock-release button.
4. Move the selector lever.
NOTE
When the ignition is switched to ACC or the ignition ...