Mazda 6 manuals

Mazda 6 Service Manual: Basic system

Refrigerant system service procedures
GAS CHARGING SET INSTALLATION 1. Fully close the valves of the SST (49 C061 001). 2. Connect the SSTs (49 C061 002, 49 C061 003) to the high- and low-pressure side joints of the SST (49 C061 001). ...

Blower unit removal/installation
1. Disconnect the negative battery cable. 2. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION.) 3. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION.) 4. Remove the blower unit. 5 ...

Other materials:

Mazda 6 Service Manual: Using LATCH Lower Anchor
Your Mazda is equipped with LATCH lower anchors for attachment of specially designed LATCH child-restraint systems in the rear seats. Both anchors must be used, otherwise the seat will bounce around and put the child in danger. Most LATCH child-restraint systems must also be used in conjunctio ...

Mazda 6 Service Manual: No.1 air bag system warning light does not illuminate
Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connec ...

© 2016-2026 Copyright www.mazda6info.net