Mazda 6 Service Manual: Automatic transaxle
- Mechanical system test
- Road test
- Automatic transaxle fluid (atf) inspection
- Automatic transaxle fluid (atf) replacement
- Hold switch inspection
- Hold switch removal/installation
- Transaxle range (tr) switch inspection
- Transaxle range (tr) switch removal/installation
- Transaxle range (tr) switch adjustment
- Transaxle fluid temperature (tft) sensor inspection
- Transaxle fluid temperature (tft) sensor removal/installation
- Oil pressure switch inspection
- Oil pressure switch removal/installation
- Input/turbine speed sensor inspection
- Input/turbine speed sensor removal/installation
- Vehicle speedometer sensor (vss) inspection
- Vehicle speedometer sensor (vss) removal/installation
- Solenoid valve inspection
- Solenoid valve removal/installation
- Pcm inspection
- Pcm removal/installation
- Automatic transaxle removal/installation
- Oil seal replacement
- Control valve body removal
- Control valve body installation
- Oil cooler flushing
- Oil cooler removal/installation
- Oil cooler disassembly/assembly
- Drive plate removal/installation
Location index
AUTOMATIC TRANSAXLE LOCATION INDEX
...
Mechanical system test
Mechanical System Test Preparation
1. Engage the parking brake and use wheel chocks at the front and rear of the
wheels.
2. Inspect the engine coolant. (See ENGINE COOLANT LEVEL INSPECTION.)
3. I ...
Other materials:
Mazda 6 Service Manual: Front brake (disc) removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, depress the pedal a few times, rotate the wheel by
hand, and verify that the brake does not drag.
Disc Plate Removal Note
Mark the wheel hub bolt and disc plate before removal ...
Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while
doing the inspection to discover whether poor contact points are the cause
of any intermittent malfunction. If
there is a problem, check to make sure connectors, terminals and ...