Mazda 6 Service Manual: Oil pressure switch removal/installation
Warning
- When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait untill they are cool before replacing ATF.
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Disconnect the cord assembly connector.
4. Remove the oil pressure switch.
5. Install the oil pressure switch.
Tightening torque 17.1-22.1N·m {1.75-2.25kgf·m, 13-16ft·lbf}
6. Connect the oil pressure switch connector.
7. Install the under cover.
8. Connect the negative battery cable.
Oil pressure switch inspection
Caution
Water or foreign objects entering the connector can cause poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
On-veh ...
Input/turbine speed sensor inspection
Caution
Water or foreign objects entering the connector can cause a poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
1. D ...
Other materials:
Mazda 6 Service Manual: Door Locks
WARNING
Always take all children and pets with you or leave a responsible person
with them: Leaving a child or a pet unattended in a parked vehicle is dangerous.
In hot weather, temperatures inside a vehicle can become high enough to cause brain
damage or even death.
Do not leave the key in ...
Mazda 6 Service Manual: A/c compressor removal/installation
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Remove the right side splash shield and mudguard (L.H.D. only).
4. Loosen the drive belt and remove it.
Caution
If moisture or foreign material enters the refrigeration ...