Mazda 6 Service Manual: Dashboard and console
- Dashboard removal/installation
- Dashboard disassembly/assembly
- Side panel removal/installation
- Column cover removal/installation
- Meter hood removal/installation
- Lower panel removal/installation
- Center box removal/installation
- Glove compartment removal/installation
- Console removal/installation
- Console disassembly/assembly
Sunroof switch inspection
1. Remove the sunroof switch.
2. Inspect for continuity between the sunroof switch terminals using an
ohmmeter.
If not as specified, replace the sunroof switch.
...
Dashboard removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the console.
4. Remove the meter hood.
5. Remove the instrument cluster.
6. Remove the column cover.
7. Remov ...
Other materials:
Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while
doing the inspection to discover whether poor contact points are the cause
of any intermittent malfunction. If
there is a problem, check to make sure connectors, terminals and ...
Mazda 6 Service Manual: Rear washer nozzle removal/installation
1. Disconnect the negative battery cable.
2. Remove the liftgate upper trim. (See LIFTGATE UPPER TRIM
REMOVAL/INSTALLATION)
3. Remove the rear washer hose from the rear washer nozzle.
4. Compress the tabs of the rear washer nozzle.
5. Pull the rear washer nozzle out to remove it.
6. Install ...