Mazda 6 Service Manual: Console disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Console removal/installation
1. For MT vehicle, remove the shift lever knob.
2. Remove the cup holder panel using a tape-wrapped screwdriver.
3. Remove the boot panel using a tape-wrapped screwdriver, disconnect the
cigaret ...
Trim
...
Other materials:
Mazda 6 Service Manual: TCS/DSC Indicator Light
This indicator light stays on for a few seconds when the ignition is switched
ON. If the TCS or DSC is operating, the indicator light flashes.
If the light stays on, the TCS, DSC or the brake assist system may have a malfunction
and they may not operate correctly. Take your vehicle to an Auth ...
Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire
A jumper wire is used to create a temporary circuit. Connect the jumper
wire between the terminals of a circuit to bypass a switch.
Caution
Do not connect a jumper wire from the power source line to a body
ground. This may cause burning or other damage to wiring harnesse ...