Mazda 6 Service Manual: Meter hood removal/installation
1. Remove the screws.
2. Pull the meter hood toward you, then detach the column cover.
3. Install in the reverse order of removal.
Column cover removal/installation
1. Detach the fit of the upper column cover from the meter hood rubber.
2. Remove the upper column cover.
3. Remove the ignition key illumination.
4. Remove the screws.
5. Remove the lower colum ...
Lower panel removal/installation
1. Remove the bonnet release lever.
2. Remove the screws.
3. Pull the lower panel toward you, then disengage clips A and tabs B from
the dashboard, and remove the lower panel.
4. Install in the ...
Other materials:
Mazda 6 Service Manual: Sas unit configuration
1. Connect the SST (WDS or equivalent) to the DLC-2.
2. Input vehicle information following the directions on the screen.
3. Select Module programming.
4. Select Programmable module installation.
5. Select the following items and perform procedures according to directions
on the screen.
...
Mazda 6 Service Manual: Electrical parts
Battery cable
Before disconnecting connectors or removing electrical parts, disconnect
the negative battery cable.
Wiring Harness
To remove the wiring harness from the clip in the
engine room, pry up the hook of the clip using a
flathead screwdriver.
...