Mazda 6 Service Manual: No.28 spark plug condition

No.27 constant voltage

Diagnostic procedure ...

Intermittent concern troubleshooting

  Vibration Method 1. If malfunction occurs or becomes worse while driving on a rough road or when engine is vibrating, perform the steps below. Note There are several reasons vehicle or ...

Other materials:

Mazda 6 Service Manual: General procedures
PRECAUTION (SUSPENSION) Wheels and Tires Removal/Installation When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}. Suspension Links Removal/Installation Tighten any part of the suspension that uses rubber bushings only after the vehicle has been lowered ...

Mazda 6 Service Manual: Rear wiper arm and blade removal/installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE ADJUSTMENT) Rear Wiper Arm Installation Note Clean the rear wiper arm connector shaft using a wire brush before installing the ...