Mazda 6 Service Manual: Manual transaxle

Location index

MANUAL TRANSAXLE LOCATION INDEX ...

Transaxle oil inspection

1. Park the vehicle on level ground. 2. Remove the oil level plug and washer. 3. Verify that the oil is near the brim of the plug port. If the oil level is lower than the low level, add the spec ...

Other materials:

Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing the ATF. 1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.) 2. Disconnect the TFT sensor connector. 3. Remove the TFT sensor. 4. Install a TFT senso ...

Mazda 6 Service Manual: Running light unit inspection
1. Connect the connector to the running light unit. 2. Connect the negative battery cable. 3. Measure the voltage at the running light unit using voltmeter. When inspecting terminal D, H or P for continuity, disconnect the running light unit connector. 4. If the value are not as specif ...