Mazda 6 Service Manual: Dtc 01

Inspection of dtcs for condition detection mode

Note The cruise set indicator light will illuminate for 3 seconds, when condition detection mode is on. If the RESUME/ACCEL switch on the cruise control switch is malfunctioning, the cruis ...

Dtc 05

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Removal/Installation
To remove the head restraint, pull it up while pressing the stop-catch. To install the head restraint, insert the legs into the holes while pressing the stop-catch. WARNING Always drive with the head restraints installed when seats are being used and make sure they are properly installed: Dri ...

Mazda 6 Service Manual: Rear shock absorber removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...