Mazda 6 manuals

Mazda 6 Service Manual: Refrigerant pressure switch inspection

Mazda 6 Service Manual / Heater and air conditioner systems / Control system / Refrigerant pressure switch inspection

1. Install the SST

(gas charging set).

2. Disconnect the refrigerant pressure switch connector.

3. Verify the high-pressure side reading of the SST

(manifold gauge) and continuity between the terminals of the refrigerant pressure switch.

Triple-pressure Type




Dual-pressure Type



Refrigerant pressure switch removal/installation
1. Remove the battery. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Loosen the refrigerant pressure switch using two spanners. 4. Remove in the order indicated i ...

Climate control unit removal
1. Disconnect the negative battery cable. 2. Disconnect the air mix and airflow mode wires from each wire clamp and link. (Manual air conditioner) 3. Remove the center panel. (See CENTER PANEL MOD ...

Other materials:

Mazda 6 Service Manual: Solenoid valve removal/installation
1. Disconnect the negative battery cable. 2. Remove the under cover. 3. Remove the control valve body. (See CONTROL VALVE BODY REMOVAL.) 4. Remove the solenoid valve(s). 5. Apply ATF to a new O-ring and install it on the solenoid valve. 6. Install the solenoid valve in the control valve body. ...

Mazda 6 Service Manual: Front door speaker inspection
1. Inspect for resistance between the front door speaker terminals using an ohmmeter. If not as specified, replace the front door speaker. 2. To verify that the front door speaker outputs sound, apply voltage to the front door speaker and release using a 1.5-V battery. If not outp ...

© 2016-2026 Copyright www.mazda6info.net