Mazda 6 Service Manual: Clutch unit

Clutch release cylinder disassembly/assembly

1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. ...

Clutch unit removal/installation

1. Remove in the order indicated in the table. 2. Install in the reverse order oremoval. Clutch Cover and Disc Removal Note 1. Install the SSTs. 2. Loosen each bolt one turn at a time in a c ...

Other materials:

Mazda 6 Service Manual: Oil pressure switch removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait untill they are cool before replacing ATF. 1. Disconnect the negative battery cable. 2. Remove the under cover. 3. Disconnect the cord assembly connector. 4. Remove the oil pressure switch. ...

Mazda 6 Service Manual: General procedures
PRECAUTION (FRONT AND REAR AXLE) Wheel and Tire Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf} Brake Line Disconnection/Connecti ...