Mazda 6 Owners Manual: Active Driving Display Maintenance (Some models)
The combiner and mirror surface have a special coating. When cleaning it, do not use a hard cloth, a cloth with a rough surface, or cleaning detergent. Use a finetextured, soft cloth.
If a chemical solvent gets on the combiner or mirror surface, wipe it off immediately. Otherwise, they could be damaged and the surface coating could be scratched.
Instrument Panel Top (Soft pad) Maintenance
Extremely soft material is used for the soft pad surface. If the soft pad surface
is rubbed harshly with a dry cloth, it could result in the surface being damaged
and leaving white scratch marks.
...
Panel Maintenance
If a panel becomes soiled, wipe it off with a soft cloth soaked in clean water
and thoroughly wrung out.
If some areas require further cleaning, use the following procedure:
1. Wipe the soiled are ...
Other materials:
Mazda 6 Owners Manual: Flasher unit inspection
1. Connect the connector to the flasher unit.
2. Connect the negative battery cable.
3. Measure the voltage at the flasher unit using voltmeter.
When inspecting terminal F for continuity, disconnect the flasher unit connector.
4. If the value are not as specified in the Terminal Voltag ...
Mazda 6 Owners Manual: Cargo compartment light switch inspection
1. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
2. Disconnect the cargo compartment light switch connector.
3. Inspect for continuity between the cargo compartment light switch
terminals using an ohmmeter.
If not as specified, replace the liftgate lock.
...