Mazda 6 Owners Manual: Panel Maintenance
If a panel becomes soiled, wipe it off with a soft cloth soaked in clean water and thoroughly wrung out.
If some areas require further cleaning, use the following procedure:
1. Wipe the soiled area with a soft cloth soaked in a mild detergent (approx. 5 %) diluted with water.
2. Wipe off the remaining detergent using a cloth soaked in clean water and wrung out well.
NOTE
Be particularly careful when cleaning shiny surface panels and metallic parts such as plating as they can be scratched easily.
Active Driving Display Maintenance (Some models)
The combiner and mirror surface have a special coating. When cleaning it, do
not use a hard cloth, a cloth with a rough surface, or cleaning detergent. Use a
finetextured, soft cloth.
If a chemic ...
Cleaning the Window Interiors
CAUTION
Do not scrape or scratch the inside of the window glass. It could damage
the thermal filaments and the antenna lines.
When washing the inside of the window glass, use a soft cloth dam ...
Other materials:
Mazda 6 Owners Manual: Thermostat
THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
5. Remove the washer tank.
6. Remove the P/S oil pump.
Note
...
Mazda 6 Owners Manual: Side protector removal
1. Pry the side protector end 20-30 mm {0.8-1.1 in} using a flathead
screwdriver or a razor.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
Note
The side protector is installed with double-sided adhesive tape.
If the side protector ...