Mazda 6 Owners Manual: Wiper Blades
CAUTION
- Hot waxes applied by automatic car washers have been known to affect the wiper's ability to clean windows.
- To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
- When the wiper lever is in the AUTO position and the ignition is switched
ON, the wipers may move automatically in the following cases:
- If the windshield above the rain sensor is touched.
- If the windshield above the rain sensor is wiped with a cloth.
- If the windshield is struck with a hand or other object.
- If the rain sensor is struck with a hand or other object from inside the vehicle.
Be careful not to pinch hands or fingers as it may cause injury, or damage the wipers. When washing or servicing the vehicle, make sure the wiper lever is in the OFF position.
Contamination of either the windshield or the blades with foreign matter can reduce wiper effectiveness. Common sources are insects, tree sap, and hot wax treatments used by some commercial car washes.
If the blades are not wiping properly, clean the window and blades with a good cleaner or mild detergent; then rinse thoroughly with clean water. Repeat if necessary.
Body Lubrication
All moving points of the body, such as door and hood hinges and locks, should
be lubricated each time the engine oil is changed. Use a nonfreezing lubricant on
locks during cold weather.
Make sur ...
Replacing Windshield Wiper Blades
When the wipers no longer clean well, the blades are probably worn or cracked.
Replace them.
CAUTION
To prevent damage to the wiper arms and other components, do not try to sweep
the wiper arm b ...
Other materials:
Mazda 6 Owners Manual: Operation
NOTE
The engine may not start and security indicator light may illuminate
or flash if the key is placed in an area where it is difficult for the system
to detect the signal, such as on the dashboard or in the glove compartment.
Move the key to a location within the signal range, switch ...
Mazda 6 Owners Manual: Dual proportioning valve replacement (without abs)
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Dual Proportioning Valve Installation Note
Install the dual proportioning valve so that the R mark faces the left side
of the vehicle.
...