Mazda 6 Service Manual: Water temperature sensor removal/installation
1. Disconnect the negative battery cable.
2. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Evaporator temperature sensor inspection
1. Turn the AUTO switch on.
2. Set the temperature control at MAX COLD (Turn the left).
3. Turn the A/C switch.
4. Set the RECIRCULATE mode.
5. Close all doors and windows.
6. Wait for 5 minutes. ...
Water temperature sensor inspection
1. Measure the temperature around the water temperature sensor.
2. Measure the resistance between terminals of the water temperature sensor.
If the resistance is not as shown in the graph, replac ...
Other materials:
Mazda 6 Service Manual: Variable valve timing actuator inspection
L3
Caution
Variable valve timing actuator can not be disassembled it is a
precision unit.
1. Disconnect the negative battery cable.
2. Remove the plug hole plate.
3. Remove the high-tension lead.
4. Remove the oil control valve connector.
5. Remove the ventilation hose.
6. Remove the ...
Mazda 6 Service Manual: Oil seal (differential) replacement
1. On level ground, jack up the vehicle and support it evenly on safety
stands.
2. Drain the oil from the transaxle.
3. Remove the front wheels and splash shields.
4. Separate the drive shaft and joint shaft from the transaxle. (See DRIVE
SHAFT REMOVAL/INSTALLATION.) (See JOINT SHAFT REMOVAL/ ...