Mazda 6 manuals

Mazda 6 Service Manual: Clutch switch inspection

Note

Continuity Inspection

1. Verify that the clutch switch is installed properly.

2. Disconnect the negative battery cable.

3. Remove the clutch switch.

4. Inspect for continuity between the clutch switch terminals using an ohmmeter.


Specification


Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)


2. Inspect the following harness for open or short. (Continuity check)

Open circuit

Short circuit

Power steering pressure (psp) switchinspection
Note Perform the following inspection only when directed. Continuity Inspection 1. Inspect the following if the power steering is inoperative (See POWER STEERING FLUID INSPECTION.): Powe ...

Neutral switch inspection
Note Perform the following inspection only when directed. Continuity Inspection 1. Disconnect the negative battery cable. 2. Remove the neutral switch.J5 MANUAL TRANSAXLE REMOVAL/INSTALLATION ...

Other materials:

Mazda 6 Service Manual: Rear window glass installation
Caution To prevent the sealant from cracking or the glass from being pushed out by air pressure if a door is closed, open all of the windows and leave them open until the sealant has hardened. 1. Cut away the old sealant using a razor so that 1-2 mm {0.04-0.07 in} thickness of sealant ...

Mazda 6 Service Manual: Hazard Warning Flasher
The hazard warning lights should always be used when you stop on or near a roadway in an emergency. The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it. Depress the hazard warning flasher and all the turn s ...

© 2016-2026 Copyright www.mazda6info.net