Mazda 6 manuals

Mazda 6 Service Manual: Starter removal/installation

Warning

When the battery cables are connected, touching the vehicle body with starter terminal B will generate sparks. This can cause personal injury, fire, and damage to the electrical components. Always disconnect the battery negative cables before performing the following operation.

1. Disconnect the negative battery cable.

2. Remove the under cover.

3. Remove the air cleaner assembly.(See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)

4. Remove the clutch release cylinger.(MTX) (See CLUTCH RELEASE CYLINDER REMOVAL/INSTALLATION.)

5. Remove in the order indicated in the table.

6. Install in the reverse order of removal.



Starting system
...

Starter inspection
On-vehicle Inspection 1. Verify that the battery is fully charged. 2. Crank the engine and verify that the starter rotates smoothly without any noise. If not, inspect the following. - Re ...

Other materials:

Mazda 6 Service Manual: Accessory Sockets
Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A). Front The ignition must be switched to ACC or ON. Center The accessory sockets can be used regardless of whether the ignition is on or off. CAUTION To prevent accessory socket damag ...

Mazda 6 Service Manual: Cruise actuator inspection
1. Disconnect the cruise actuator connector. 2. Measure the voltage, continuity and resistance at the cruise actuator terminals as indicated below. If not as specified, inspect the parts listed under Action. If the parts and wiring harnesses are okay but the system still does not work pr ...

© 2016-2026 Copyright www.mazda6info.net