Mazda 6 Service Manual: Power window motor inspection
Drivers Side
1. Disconnect the power window motor connector.
2. Apply battery positive voltage to the power window motor terminals E and F and inspect the operation the power window motor operation.
- If not as specified, replace the power window motor.
3. Apply battery positive voltage
to the power window motor terminal D and connect terminal C to ground.
4. Measure the voltage at terminal B and A while performing Step 3.
- If not as specified, replace the power window motor.
Voltage
Pulse wave: MAX. 5 V, MIN. 0 V
Except Driver's Side
Apply battery positive voltage to the power window motor terminals and inspect the operation of the power window motor.
- If not as specified, replace the power window motor.
Power window motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door trim or rear door trim.
3. Disconnect the power window motor connector.
4. Remove the bolts.
5. Remove the power window motor f ...
Other materials:
Mazda 6 Service Manual: Trunk Lid
WARNING
Never allow a person to ride in the trunk: Allowing a person to ride
in the trunk is dangerous. The person in the trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the trunk lid open: Exhaust gas in the cabin of a vehicle
is dangerous. ...
Mazda 6 Service Manual: Rear door unit removal/installation
1. Remove the rear door glass.
2. Remove the inner handle.
3. Remove the rear door speaker.
4. Disconnect the power window motor connector, and power door lock actuator
connector.
5. Remove the rear door harness from the rear door unit.
6. Remove the bolts.
7. Remove the rear door lock act ...