Mazda 6 manuals

Mazda 6 Service Manual: No.8 no cool air


Diagnostic procedure



No.7 air from vents cold enough
Diagnostic procedure ...

No.9 noise while operating a/c system
Diagnostic procedure * : If there is gas leakage, air enters into the A/C system. The desiccant within the receiver/drier absorbs the moisture from the air and becomes saturated. If the A/C ...

Other materials:

Mazda 6 Service Manual: Overheating
If the high engine coolant temperature warning light turns on, the vehicle loses power, or you hear a loud knocking or pinging noise, the engine is probably too hot. WARNING Pull over to a safe location, then switch the ignition off and make sure the fan is not running before attempting t ...

Mazda 6 Service Manual: Oil cooler removal/installation
1. Disconnect the negative battery cable. 2. Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.) 3. Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION.) 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 6. Add ATF to ...

© 2016-2026 Copyright www.mazda6info.net