Mazda 6 Service Manual: Troubleshooting
Mazda 6 Service Manual / Heater and air conditioner systems / Troubleshooting
- Foreword
- Troubleshooting index
- No.1 insufficient air (or no air) blown from vents
- No.2 amount of air blown from vents does not change
- No.3 amount of air blown from vents does not change
- No.4 air intake mode does not change
- No.5 no temperature control with climate control unit
- No.6 windshield fogged
- No.7 air from vents cold enough
- No.8 no cool air
- No.9 noise while operating a/c system
Dtc 19, 22 (when two or more dtcs are indicated at the same time)
Diagnostic Procedure
...
Foreword
The areas for inspection (steps) are given according to various circuit
malfunctions. Use the following chart to verify the symptoms of the trouble
in order to diagnose the appropriate area.
...
Other materials:
Mazda 6 Service Manual: Clock spring inspection
1. Remove the clock spring.
2. Inspect for continuity between the clock spring terminals using an
ohmmeter.
If not as specified, replace the clock spring.
Note
When the vehicle-side connector of clock spring is disconnected,
the terminals 1A,1B, 1C and 1D are shorted to prevent ...
Mazda 6 Service Manual: Engine Coolant Temperature Gauge
Displays the engine coolant temperature. The blue gauge indicates that the engine
coolant temperature is low, and the red gauge indicates that the engine coolant
temperature is high and overheating.
CAUTION
If the high engine coolant temperature warning light (red) turns on, there
is a pos ...
© 2016-2026 Copyright www.mazda6info.net