Mazda 6 Service Manual: Liftgate upper trim removal/installation

Mazda 6 Service Manual / Body / Trim / Liftgate upper trim removal/installation

1. Pull the liftgate upper trim toward you, then disengage clips A, and pin B from the body.

2. Remove the liftgate upper trim.

3. Install in the reverse order of removal.

Trunk end trim removal/installation

4SD 1. Remove the fasteners. 2. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks. 3. Remove the trunk end trim. 4. Install in the reverse order of removal. 5HB 1. Pull ...

Liftgate side trim removal/installation

1. Remove the liftgate upper trim. 2. Position the strap hanger as shown in the figure. 3. Pull the liftgate side trim toward you, then disengage clips A, pin B and the strap hanger from the bod ...

Other materials:

Mazda 6 Service Manual: Manifold absolute pressure (map) sensor inspection
Note Perform the following inspection only when directed. The following vacuum values are indicated by relative pressure from the MAP sensor. 1. Connect the SSTs (WDS or equivalent) to the DLC-2. 2. Turn the ignition switch to ON (Engine OFF). 3. Select MAP PID on the SSTs (WDS or equi ...

Mazda 6 Service Manual: Interior
Front Rear ...