Mazda 6 Service Manual: Fuse block removal/installation
1. Disconnect the negative battery cable.
2. Remove the left-side front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Main fuse removal/installation
1. Disconnect the negative battery cable.
2. Remove the main fuse block cover.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Bolt Removal Note
1. ...
Ignition switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of r ...
Other materials:
Mazda 6 Service Manual: Engine coolant
ENGINE COOLANT LEVEL INSPECTION
Verify that the coolant level in the coolant reservoir is between the F and L
marks.
If the engine coolant level is below L, remove the radiator cap and add
coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
ENGINE COOLANT REPLACEMENT
Warning
Drain the ...
Mazda 6 Service Manual: Panel light control switch inspection
1. Connect the connector to the panel light control switch.
2. Connect the negative battery cable.
3. Measure the voltage at the panel light control switch using voltmeter.
When inspecting terminal B for continuity, disconnect the panel light
control switch connector.
4. If the value are ...