Mazda 6 Service Manual: Troubleshooting
Mazda 6 Service Manual / Body electrical system / Troubleshooting
- Car-navigation system
- No.1 while vehicle is in reverse, vehicle locator mark goes forward
- No.2 in navigation mode, vehicle locator mark skips
- No.3 even when headlight switch is turned on, daytime screen does not change to night time screen. (front and rear combination lights operate normally.)
- Air bag system
- No.1 air bag system warning light does not illuminate
- No.2 air bag system warning light is illuminated all the time
- No.3 passenger-side air bag cut-off indicator light does not illuminate
- No.4 passenger-side air bag cut-off indicator light is illuminated all the time
Dtc b2867
Diagnostic procedure
...
Car-navigation system
Troubleshooting Index
Use the chart below verify the trouble in order to diagnose the
appropriate area.
...
Other materials:
Mazda 6 Service Manual: Trailing link removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...
Mazda 6 Service Manual: Clutch disc inspection
1. Using vernier calipers, measure the thickness of the lining at a rivet
head on both sides.
Replace the clutch disc if its thickness is less than the minimum.
Thickness
0.3 mm {0.012 in} min.
2. Measure the clutch disc runout using a dial indicator.
If the runout is excessiv ...
© 2016-2024 Copyright www.mazda6info.net