Mazda 6 Service Manual: No.1 air bag system warning light does not illuminate

Mazda 6 Service Manual / Body electrical system / Troubleshooting / No.1 air bag system warning light does not illuminate

Diagnostic Procedure

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and undamaged.

Air bag system

Troubleshooting Index Use the chart below verify the symptoms of the trouble in order to diagnose the appropriate area. ...

No.2 air bag system warning light is illuminated all the time

Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact point ...

Other materials:

Mazda 6 Service Manual: Combine sensor inspection
Caution Be careful and do not allow the lateral-G sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Connect the connector. 2. Turn ignition switch on, verify the voltage between terminals B and E under the following conditions. If not within the specifi ...

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...