Mazda 6 manuals

Mazda 6 Service Manual: Rear axle

Wheel hub, steering knuckle removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Wheel hub, hub spindle pre-inspection
Wheel Bearing Play Inspection 1. Position a dial indicator against the wheel hub. 2. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play. Maximum wh ...

Other materials:

Mazda 6 Service Manual: Bonnet switch inspection
Note Bonnet switch has a built-in bonnet lock. 1. Open the bonnet. 2. Disconnect the negative battery cable. 3. Remove the radiator grille. 4. Disconnect the bonnet switch connector. 5. Check the continuity between the bonnet switch terminals A and B using an ohmmeter. If there is ...

Mazda 6 Service Manual: A/c unit removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.) 4. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION.) 5. Remove the theft-deterrent control module. (See ...

© 2016-2026 Copyright www.mazda6info.net