Mazda 6 Owners Manual: Operation
System triggering conditions
The horn sounds intermittently and the hazard warning lights flash for about 30 seconds when the system is triggered by any one of the following:
- Unlocking a door with the key, door lock switch, or an inside door-lock knob.
- Forcing open a door, the hood or the trunk lid.
- Opening the hood by operating the hood release handle.
- Switching the ignition ON without using the push button start.
If the system is triggered again, the lights and horn will activate until the driver's door or the trunk lid is unlocked with the transmitter.
(With the advanced keyless function)
The lights and horn can also be deactivated by pressing the request switch on a door.
NOTE
If the battery goes dead while the theftdeterrent system is armed, the horn will activate and the hazard warning lights will flash when the battery is charged or replaced.
Theft-Deterrent System (Some models)
If the theft-deterrent system detects an inappropriate entry into the vehicle,
which could result in the vehicle or its contents being stolen, the alarm alerts
the surrounding area of an abnormali ...
How to Arm the System
1. Close the windows and the moonroof securely (some models).
2. Switch the ignition OFF.
3. Make sure the hood, the doors, and the trunk lid are closed.
4.Press the lock button on the transm ...
Other materials:
Mazda 6 Owners Manual: Schedule 2
U.S.A. and Puerto Rico residents - Severe driving conditions maintenance interval
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
R: Replace
L: Lubricate
T: Tighten
Remarks:
*1 Engine oil flexible maintenance is available for U.S.A. and Pu ...
Mazda 6 Owners Manual: Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along
the direction (1) shown in the figu ...