Mazda 6 Owners Manual: Opening the Hood
1. With the vehicle parked, pull the release handle to unlock the hood.
2. Insert your hand into the hood opening, slide the latch lever to the right, and lift up the hood.
NOTE
The lever is located a little to the left of center when facing the vehicle.
3. Grasp the support rod in the padded area and secure it in the support rod hole indicated by the arrow to hold the hood open.
Hood
WARNING
Always check that the hood is closed and securely locked: A hood
that is not closed and securely locked is dangerous as it could fly open while the
vehicle is moving and block the driver' ...
Closing the Hood
1. Check under the hood area to make certain all filler caps are in place and
all loose items (e.g. tools, oil containers, etc.) have been removed.
2. Lift the hood, grasp the padded area on the su ...
Other materials:
Mazda 6 Owners Manual: Rear oil seal
REAR OIL SEAL REPLACEMENT
1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION)
2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear Oil Seal Installation Note
...
Mazda 6 Owners Manual: Steering gear and linkage removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...