Mazda 6 manuals

Mazda 6 Service Manual: No.10 low idle/stalls during deceleration

Mazda 6 Service Manual / Fuel and emission control systems / Troubleshooting / No.10 low idle/stalls during deceleration


Diagnostic procedure



No.9 fast idle/runs on
Diagnostic procedure ...

No.11 engine stalls/quits, engine runs rough, misses, buck/jerk, hesitation/stumble, surges
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: To Resume Cruising Speed at More Than 25 km/h (16 mph)
If some other method besides the OFF/ CANCEL switch was used to cancel cruising speed (such as applying the brake pedal) and the system is still activated, the most recent set speed will automatically resume when the RESUME/ switch is pressed. If vehicle speed is below 25 km/h (16 mph), incre ...

Mazda 6 Service Manual: Coil removal/installation
Note Do not remove the coil unless you are replacing it. When only the coil is replaced, the immobilizer system reprogram procedure is not necessary. 1. Disconnect the negative battery cable. 2. Remove the column cover. 3. Remove in the order indicated in the table. 4. Install in ...

© 2016-2026 Copyright www.mazda6info.net