To remove the jack
1. Lift the trunk mat.

2. Remove the pocket.

3. Turn the wing bolt and jack screw counterclockwise.

To secure the jack
1. Insert the wing bolt into the jack with the jack screw pointing to the front and turn the wing bolt clockwise to temporarily tighten it.
2. Turn the jack screw in the direction shown in the figure.

3. Turn the wing bolt completely to secure the jack.
NOTE
If the jack is not completely secured, it could rattle while driving. Make sure the jack screw is sufficiently tightened.
Maintenance
Spare Tire and Tool Storage
Spare TireMazda 6 Owners Manual: Shift Gear (Shifting) Speed Limit
For each gear position while in the manual mode, the speed limit is set as follows:
When the selector lever is operated within the range of the speed limit, the gear
is shifted.
Shift up
The gear does not shift up while the vehicle speed is lower than the speed limit.
Shift down
The gear d ...
Mazda 6 Owners Manual: No.6 windshield fogged
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunctions. If there
is a problem, check to make sure connectors, terminals and wir ...