Mazda 6 Service Manual: Fuel system

Accelerator cable inspection/adjustment

1. Verify that the throttle valve is closed. 2. Pull the accelerator cable in the directions of A and B, and measure the free play. If not as specified, adjust by turning locknut C. Free ...

Before repair procedure

Warning Fuel vapor is hazardous. It can easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakage are dangerous. Fuel can ig ...

Other materials:

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

Mazda 6 Service Manual: Refrigerant pressure switch removal/installation
1. Remove the battery. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Loosen the refrigerant pressure switch using two spanners. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. Refrigerant Pressure Switch Installat ...