Mazda 6 Service Manual: Fuel pump unit disassembly/assembly
Warning
- Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, do not damage the sealing surface of the fuel pump unit when removing or installing.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Fuel pump unit removal/installation
Warning
Fuel line spills and leakage are dangerous. Fuel can ignite and
cause serious injuries or death and damage. Fuel can also irritate skin and
eyes. To prevent this, do not damage the s ...
Fuel pump unit inspection
Caution
It is normal to hear the fuel pump operating when the ignition
switch is turned to the ON position.
Note
To improve startability, the fuel pump control operates the fuel
pump ...
Other materials:
Mazda 6 Service Manual: Seat warmer unit inspection
1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.)
2. Remove the seat cushion trim.
3. While inspecting for continuity between the terminals A and B of the
connector, use a dryer to warm the thermostat of the seat warmer unit on seat
cushion.
4. When the indication on the ohmm ...
Mazda 6 Service Manual: Manifold absolute pressure (map) sensor inspection
Note
Perform the following inspection only when directed.
The following vacuum values are indicated by relative pressure
from the MAP sensor.
1. Connect the SSTs (WDS or equivalent) to the DLC-2.
2. Turn the ignition switch to ON (Engine OFF).
3. Select MAP PID on the SSTs (WDS or equi ...