Mazda 6 Owners Manual: Fuel Economy Monitor
The Control Status and Fuel Consumption are switched and displayed by operating each icon in the display.
In addition, after completing a trip, the total energy efficiency to date is displayed in the ending display when the ending display is turned on.
1. Select the 
icon on the home
screen to display the applications screen.
2. Select the “Fuel Economy Monitor”.
3. Operate the commander switch or touch the screen and display the menu.
NOTE
When the menu is displayed by touching the screen, the display is hidden automatically after 6 seconds.
4. Select the icon in the menu and perform the operation. Each icon operates as follows:
NOTE
The fuel economy monitor screen after the ignition is switched from ON to OFF is changed to the original fuel economy monitor screen when the ignition is switched ON the next time.
Fuel Consumption Display
Information regarding the fuel economy is displayed.
NOTE
- The fuel economy data can be reset by doing the following operation:
- Press the reset switch from the menu screen.
- When the function which synchronizes the fuel economy monitor and the trip meter is on, reset trip A of the trip meter.
- Delete the average fuel economy information displayed in the trip computer.
- After resetting the fuel economy data, “-- -
” is displayed while the average fuel economy is calculated.
Control Status Display
The power generating status is displayed
Ending Screen Display
If the ending display on the fuel economy monitor is on when the ignition is switched from ON to OFF, the information regarding the fuel economy is displayed.
i-ELOOP
i-ELOOP is a regenerative braking system. When you depress the brake pedal or
use engine braking, the kinetic energy that occurs is converted to electrical energy
by the power generator and the co ...
Drive Selection (Some models)
Drive selection is a system to switch the vehicle's drive mode. When the sport
mode is selected, vehicle's response against accelerator operation is enhanced.
This provides additional quick accele ...
Other materials:
Mazda 6 Owners Manual: Rear door glass removal/installation
1. Fully down the rear door glass.
2. Remove the rear door trim.
3. Remove the hole cover.
4. Pull up the rear door weatherstrip and remove the screw.
5. Remove the bolt.
6. Remove the glass run channel from the rear door glass guide.
7. Lift the rear door glass to the position where the rea ...
Mazda 6 Owners Manual: Bonnet switch inspection
Note
Bonnet switch has a built-in bonnet lock.
1. Open the bonnet.
2. Disconnect the negative battery cable.
3. Remove the radiator grille.
4. Disconnect the bonnet switch connector.
5. Check the continuity between the bonnet switch terminals A and B using an
ohmmeter.
If there is ...