Mazda 6 manuals

Mazda 6 Service Manual: Front fog light bulb removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Front fog light bulb removal/installation

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.



Caution

3. Install in the reverse order of removal.

Front Fog Light Bulb Removal Note

Release the bulb pressing wire to remove the front fog light bulb.

Front fog light aiming
1. Adjust the tire air pressure to the specification. 2. Position the unloaded vehicle on a flat, level surface. 3. Seat one person in the drivers seat. 4. Position the vehicle 3 m {10 ft} in front ...

Rear combination light removal/installation
1. Disconnect the negative battery cable. 2. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. 4. Install in the reverse orde ...

Other materials:

Mazda 6 Service Manual: Parking brake (lever type) removal/installation
1. Remove the center console. (See CONSOLE REMOVAL/INSTALLATION.) 2. Remove the rear seat cushion (4SD) or rear seat (5HB) . (See REAR SEAT REMOVAL/ INSTALLATION.) 3. Remove the exhaust pipe bracket. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 6 ...

Mazda 6 Service Manual: Compression pressure
COMPRESSION INSPECTION Warning Hot engines and oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component. 1. Verify that the battery is fully charged. Recharge it if necessary. (See BATTERY INSPECTION.) 2. Warm up the engine to the no ...

© 2016-2026 Copyright www.mazda6info.net