Mazda 6 Service Manual: Dtc c1280, c1730, c1951, c1952, c1959
Caution
- When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used.
Diagnostic procedure
Dtc c1194, c1198, c1210, c1214, c1242, c1246, c1250, c1254, c1400, c1410,
c1957, c1958
Diagnostic procedure
...
Dtc c1414
Diagnostic procedure
...
Other materials:
Mazda 6 Service Manual: Ignition coil inspection
Primary Coil Winding
1. Remove the ignition coil.
2. Measure the resistance between the following lead holes using an ohmmeter.
A and B, B and C
- If not specified, replace the ignition coil.
Specification
0.49-0.57 ohms [20°C {68°F}]
Secondary Coil Winding
1. Remove the igni ...
Mazda 6 Service Manual: No.8 brake system warning light stays on more than 4 seconds with ignition
switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure co ...