Mazda 6 manuals

Mazda 6 Service Manual: Combine sensor removal/installation

Mazda 6 Service Manual / Braking system / Dynamic stability control / Combine sensor removal/installation

Caution

1. Remove the center console.

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

4. After installation, perform the combine sensor initialization procedure. (See COMBINE SENSOR INITIALIZATION PROCEDURE.)

Dsc hu/cm inspection
1. Remove the battery and battery bracket. 2. Disconnect the DSC HU/CM connector. 3. Connect the SST (49 G066 004) to the DSC HU/CM connector and harness side connector. 4. Inspect voltage referr ...

Combine sensor inspection
Caution Be careful and do not allow the lateral-G sensor to fall. If by chance it is subjected to strong impact, replace it. 1. Connect the connector. 2. Turn ignition switch on, verify the ...

Other materials:

Mazda 6 Service Manual: Foreword
When the customer reports a vehicle malfunction, check the malfunction indicator lamp (MIL), HOLD indicator light flashing, and PCM memory for diagnostic trouble code (DTC), then diagnose the malfunction according to following flowchart. - If the DTC exists, diagnose the applicable ...

Mazda 6 Service Manual: Joint shaft removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor and fix it to an appropriate place wh ...

© 2016-2026 Copyright www.mazda6info.net