Mazda 6 Service Manual: Combination switch disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Combination switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
3. Remove the steering wheel. (See STEERING WHEEL AND COL ...
Steering angle sensor inspection
With DSC
1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
2. Disconnect the steering angle sensor connector.
3. Connect battery positive voltage to terminal A and ground to termi ...
Other materials:
Mazda 6 Service Manual: Jacking positions ,vehicle lift (2 supports),safety stands (rigid rack)
positions
Jacking Positions
Warning
Improperly jacking a vehicle is dangerous. The vehicle can slip
off the jack and cause serious injury. Use only the correct front and rear
jacking points and block the wheels.
Use safety stands to support the vehicle after it has been lifted.
Fro ...
Mazda 6 Service Manual: Front fender panel
FRONT FENDER PANEL REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front side turn light.
3. Remove the fender molding. (See COWL GRILLE REMOVAL/INSTALLATION.)
4. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
5. Remove the front combination light ...